modern yokomo big bore shocks

[bully]

Anyone who runs modern yokomo x shocks know how to get the o rings separately? I have only seen the shaft o rings and adjustment nut o rings available separately but not the top caps and bottom caps.. I have looked at the team associated big bore rebuild kits wondering wether they would work for the top and bottom caps,and I can just use the yokomo shaft o rings.... On the yokomo shaft o rings what are most people using the clear whitish or the blue ones? Thanks everyone..

[stickboy007]

You should measure the diameter of the shock shafts. Chances are, they are 3mm shafts, in which case you can at least use AE or Kyosho o-rings. As for the adjustment o-ring, if the shock body diameter matches that of other big bore shocks (and I suspect it would), then the same answer applies here as well.

[bully]

Shaft and adjustment o rings are not what I was asking about mate.. I asked about the top and bottom cap o rings

[stickboy007]

Oops. Well...all big bores are the same diameter, right? I would expect all of the o-rings to be the same size.

[bully]

That's what I was thinking thanks mate no worries...

[works92]

you're right, yokomo doesn't sell separetly the top and bottom caps o ring.
personaly i'm just re-using the originals ones with some green grease and they're not leaking.
for the shaft o ring , i use to put the whitish, but with the new bottom caps i'm gonna test 1blue and 1whitish per cartridge.

[bully]

Yeah thanks mate I am gonna get the v2 upgrade for the bottom cap myself when I get some spare coin.. Thanks for sharing about the shaft o rings mate.