i picked up a gold tub rc10 locally and also got a graphite chassis with it, i am trying to switch evrything over to the graphite chassis . When i put the steering arms in i noticed the threaded ball ends come real close to the chassis is the install right i have took a picture, i wonder if the washer is enough.
thanks Brandon
when your using the stock bellcrank on a graphite chassis, you need to use an 8/32 nut under the bellcrank, to actually tighten the screw to the chassis first. the nut is taller than the washer, and should solve your clearance issue.
ok, I borrowed the pic from 59burst but these are the same bell-cranks I'm trying to install on my DS.
DSCF7345.JPG
I tried using the standard flat top screws, but they are too short. So I used two short Truck nose plate screws but there is a lot...
Last post
I've had several sets of these and am not impressed. RPM made a better set up later on that accomodates bearings. I think the best you can do on these is to make sure they are oiled/greased.
Well I got them on the DS I just finished and I Kinda...
So I'm trying to put lunsford turnbuckles on my zx5 but I have ran into a snag. The RPM ball caps don't seem to be the right size(to small). Is this correct or am I just being a tard? can I only use the stock black ball caps that came on the ZX5?
Last post
Kyosho is 3mm & Losi is 4-40...I dont recommend putting 4-40 into a 3mm used hole. But if the parts were new, no issues.
I picked a set up on E-bay and when they came they looked like they've been under water for a long time :twisted: ... the bearings are rusted solid!!! I need to know what size the bearings are so I can hit the hobby shop for a new set?
Last post
Thanks for the info guys, I got the nuts with the bellcranks, just thought that I needed screws like the DS has???
so i been slowly working on my hotshot re-re.... finally got to the servo/electronics setup...
is there anyway to increase steering a bit on these cars? basically the steering is a direct servo turn (like frog and others). no bellcranks or anything...
Last post
Just wanted to update the ball raced steering option I have gone with. Obviously I have fabricated a base plate from 1.6mm fibreglass which is held in place through the original servo mounting holes. It took some working out to get this right. Ive...
I am going though a semi-buggy conversion of a RC10T I found locally.. I just picked up a set of aluminum bellcranks from an RC10 and noticed my steering was all messed up - (see pic below)... I had to lengthen the linkage between the crank arms to...
Last post
Post deleted - I guess I did have the other holes... DOH!!!
What options do I have (without having to drill my chassis) to upgrade my steering bellcrank? I currently have the original that came with the kit installed. I would love to upgrade to a higher level of steering, though. I'd like...
I have a black ball bearing steering kitt that came with my team car and the bearings are rusted fom sitting so long. what size are they? anyone have an idea??
Last post
thanks im gonna add them to my Avid order tomorrow.
The manual shows the Worlds car being built with a black 6254 bell crank steering but I saw another one in a online French museum with white bell cranks. So is white correct, was it first supplied and then replaced with black?
Last post
I deferred to the written word in the manual and went with white. I think it looks better in white and it also justifies the $45 the white nip bell crank steering set me back.