People are bugging me today, so decided to pull one of my 1/10 MT's off the shelf and do a little work on it today to relax. Last time I ran it it was making a bit of an odd sound from the rear axle. It's a Clod axle truck with metal spur gear and HD shafts and all so was wondering what the noise might be and was hoping it was not an actual major internal gear problem. Didn't take long to find out what it was.
I honestly can't recall what brand it was. I picked up a pair of them for this truck (dual motors) when I built it about 3-4 yrs ago and memory isn't as good as it used to be.
I purchased a I purchased a TrackStar 120A Gen II ESC that I have tried to install. But I can't get throe the whole installation sequence, so I need your help guys! This is my first brushless system... :oops:
bild82.jpg
Last post
I don't think anybody here knew you were using a stick transmitter. :shock:
When I install my battery pack, the wires have to make an immediate 90 degree bend upwards and rub hard on the steering servo. There isn't enough room so the wires can come out at a better angle. Is there something I can do to correct this?
Last post
This is always a source of frustration for me. Then i look at all these fantastic builds here and it looks like the servos are right where my wires would go. :(
I have a duratrax 3000mah battery and this seems shorter then the 3800mah batteries I...
Hey I bought a new 8.4 for my rc10 b4 and it runs slower than my 7.2 battery. I tried the battery on other cars and it works fine. Can anybody help me with what's going on?
Last post
Ok so tried a lipo in this car and all I can say is WOW,this thing is crazy now,I can see why you all suggest lipo
I have a small problem with my computer. Earlier today I noticed that the click sound went away while I was web surfing. I found out how to turn the click sound back on, but now i notice a very annoying delay of 5-10 seconds while clicking around...
Last post
Since it's only affecting your profile, there might be spyware. It could be tracking what sites you're visiting, hence the delays when clicking. I find that Malwarebytes Anti-Malware is particularly effective at getting rid of low-level malware, and...
I've been gathering RPM parts for a while now. I have a used 91 worlds front end kit and cleaned it up with super clean and everything was great. I took a yellowed 10t front bulkhead and did the peroxide bath and all went well. I tend to get...
Last post
What does the distilled water do? Does the lack of minerals and boiling help them come back somewhat. Almost like a cleansing?
Hey guys Iwas looking at servos for my buggy and wanted a pretty quick servo. When I started looking at prices I realized servos were not very cheap. While at A Main, I found some Power HD servos that were really fast at a reasonable price ($33). I...
Last post
Did you try testing the servo on another receiver to eliminate the receiver as a possible cause?