Aluminium Spring Cups

[myfordcnc]

Was wondering if anybody knew if these would fit the top loading gold shocks. If I knew the diameter that would be great. Normally I would just buy them and see but they are a little pricey so wanted to check here first.

Shock Spring Cups

[aip47-2008]

Says there for the Losi 8, which is 1/8 scale. Probably way to big. HG Hammad Ghuman made aluminum shock parts for the RC10.........a bit hard to find though.

[Y'ernat Al]

Googled a pic for ya..

[myfordcnc]

I see. OK. Thanks for the info.

[chophead69]

check ebay item181176984173 they are for b4 shocks but they should work

[myfordcnc]

Cool just bought a set. Thanks

[DMAT]

let me know how those fit please.

[GoMachV]

I thought losi springs were always larger diameter than associated but they say it works for both. Guess you will find out

[THUNDERSTRIKE1]

TO USE losi springs u haft to use spring ring top and losi spring cup bottom,If not the spring pops up over top spring clamp or over the bottom cup.don

[GoMachV]

Agreed, but this is the other way around. That's why I was wondering if it will really fit associated springs. Worst case you could use Losi's.

[THUNDERSTRIKE1]

Could turn them down on machine to fit the springs the reanno them.don

[Y'ernat Al]

Agreed, but this is the other way around. That's why I was wondering if it will really fit associated springs. Worst case you could use Losi's.

And then you don't wear the ano off the outside of your 1:32 body by using a spring that imo, is too small. Once I started using losi springs, I can't go back to the tiny ae ones. My nit-pickiness, but I have this theory that you get a much smoother shock when the spring isn't bending sideways and scraping on the shock body.

[myfordcnc]

That's a pretty good point. I had noticed that, the scraping of the shock body. I'll try both.