Hey guys...I know this may sound weird, but I've never owned a six gear transmission. All of my builds have either been a stealth or a variation. Anyways, I have a few questions:
1) The spur gear seems to have a little play, like a hair of...
Last post
I slipped a shim in there (after I put in the shim I missed on the idler shaft) and it took out most of the movement. While I had the gearbox apart it definitely looks like that is the side where the gears line up best.
so this is more of an after the thought question on an issue i had.
so after doing some high speed runs with my car. the rear end started to bind up really bad. became hard to turn. since it still turned and i didnt feel any grinding, i thought it...
Last post
well this has now turned into trying to make the tranny have a little friction as possible. i've removed the bearings, cleaned out the gears of which i found some slivers of gears caught in the outdrive teeth so the issue with the outdrives and...
What is the best (easily available) lube to use in the six gear transmission? Thanks. :)
Last post
I've had good luck running them dry in the past, however in the last few i rebuilt i put green slime on the thrust bearing and a very light machine oil on the 6 gears...most of the oil spins off but they stay wet and it seems to run very...
I am now determined to rebuild his thing and make it spin at least 16 seconds! I already took it apart and started working on it. I'm ordering ABEC 7 ceramic bearings for it. What I have now are ABEC 1s. ABEC meaning how well the bearings turn. When...
Last post
Do the outdrive slots have any raised burrs on them from dogbone wear? That can make the bearings hard to press over the outdrive.
The outdrives got a quick freshening with a small file for any burrs, and a super quick polishing for surface rust....
I'm pretty sure I've seen this posted somewhere on here before, but how do you put an RC10B4 slipper clutch on a 6 gear transmission? I know I need the B4 top shaft and the V2(?) clutch plates along with the clutch discs and gear.
Is that it or do...
Last post
just get it from here, if you access on to BST thread the you can post in the Wanted section.
Does anyone know what kind of bolt goes on the end of the differential shaft? Mine stripped out and I don't have any more, there is not a part number in the original manual.
Last post
I hope you or the previous owner didn't put a 4-40 nut on that shaft. That would pretty much do it it.
