This was listed on Ebay as T2. It is not as I am comparing to to a T2 I just scored as well. It is also not the same as my B4.1 but the chassis recessed part is about the same size and shape as that, rectangular vs. hole in the T2 chassis which is...
Last post
Is there an advantage to using a T3/B3 setup in a 10T gear case? Would it fit?
it won't fit.
Im trying to get my RC10 back on the track! I have a Composite Craft chassis for the 6 gear tranny! My problem is I have no tranny for it! I will be running brushless 13.5 or 17.5! What is my best option!
I would like to put a 3 stealth in but there...
Last post
Finally found a stealth tranny! Now I just need the mailman to hurry up, so I can start my build :twisted:
I am 13 years old and have a couple of RC 10T's that are almost twice as old as me and I enjoy driving them. But I keep destroying the idler gear out of the transmission. I have loosened the slipper clutch so that way it is putting less...
Last post
As long as they're not meaty monster truck tires that shouldn't be the problem.
I want to go brushless on my b3 but I'm assuming the original stealth tranny won't be able to handle the power and scatter it...so what would be the easiest way to change it? Just buy all the b4 stuff? Or the thunder tiger xb's? Thanx
Last post
update:
Idler gear itself fits BUT you do need different bearings and also the shaft is different. This means you also would need the TT trans. case. :(
I need some help. There is an A stamp on the bottom chassis of the car. Is this a 6-gear transmission or could this be a stealth?
I recently changed the old electronics to a brushless Castle Sidewinder 4600 kv motor/esc combo and 2s Lipo. I ran...
Last post
No, not an easy way to adjust timing on a sealed endbell. Cut brushes can adjust timing but are fragile and don't last long.
I have an RC10 Trackmaster transmission that needs a little work but has a lot of potential. However the big hurdle is it needs outdrive cups. Anyone found outdrive options that will work with it? Preferably something affordable. I am kinda cheap....
Last post
CSC Slider Shafts, or the cups from a Bolink Invader with the independent rear arms would be options.
I'm going to try the hardened PITA direction first. 😁
Just built a masami edition (2nd one) added pro transmission and can’t get it to run freely,
My 1st built with standard trans is free the 2nd seems to have a lot of drag? Is it just me or anyone Aldean have the same problem
Last post
It will probably be solved by now, but check the clearance in the front housing and surrounding parts. The front pulley rubs on the lexan undertray.
I got a kit off of ebay with a bunch of spare white parts, and there was a transmission case with it that I have not seen before. It is a 6 gear case but appears to be machined, not moulded. The nylon also appears to be denser and it is a lot...