Losi Junior Pro Se

Post by **sixdub** » Sat Apr 12, 2025 6:45 pm

Inspiration for the thread title.

Post by **RogueIV** » Wed Apr 16, 2025 1:00 pm

I actually have a jr2 chassis with the sides cut in my pile of spares. Kinda wish i caught tou before you shaved the sides on yours lol.

Post by **sixdub** » Wed Apr 16, 2025 8:17 pm

RogueIV wrote: ↑Wed Apr 16, 2025 1:00 pm I actually have a jr2 chassis with the sides cut in my pile of spares. Kinda wish i caught tou before you shaved the sides on yours lol.

Thanks for the offer. I have a few more Jr2s including a NIP in the stash, so it was a bit relaxing to cut on this one. The bottom is pretty nice, however, so not too relaxing.

Had a few minutes at the bench to start to bolt things together.

I tried the Dragonpunch Ti shock shafts. They are a bit rough compered to OEM Losis (on the right).

They look good assembled with the MIP bodies- but would not use them on a serious runner. They'd chew up the o-rings with a quickness.

The 4-40 ballstuds are quite nice, though.

The ballstuds fit well with RPM ends.

Mix in some Lunsford Ti turnbuckles. Gonna perform so well on the shelf.

RC10Talk - The Net's Largest Vintage R/C Community