CAT build

[DennisM]

And now - put i all in a big box and give it a good shake.
Last time i forgot to put the manual in the box - so clearly nothing happend.

[Mad Racer]

Update pic's please.

Can't wait to see it.

Cheers

Mark

[DennisM]

Here´s an update picture
Not much progress - I keep running into missing parts. I´ll have to have a word with the guy who planned this build

[DennisM]

A small update -
Hence the newest development in CAT prices I´ve gone into warp speed to finish this one off.
Still missing a couple of parts, guess I´ll miss the gold rush

[DennisM]

Now with wheels.
Going to order a repro body and undertray at penguin.

[Neils74]

A lovely job well done, looks like we are at about the same stage.
Have you had any luck finding rear wing buttons, Im nearly getting to the point of buying a lathe and making the damn things myself.
Please let me know how the penguin shell works out, I did read that somewhere that they ran a little thin in parts of the moulding.

[kaszal]

Have you also considered Kamtec? They've been making shells for years. My Procat shell from them seems very good. I got some undertrays from Team Bluegroove.

[DennisM]

A lovely job well done, looks like we are at about the same stage.
Have you had any luck finding rear wing buttons, Im nearly getting to the point of buying a lathe and making the damn things myself.
Please let me know how the penguin shell works out, I did read that somewhere that they ran a little thin in parts of the moulding.

Thanks -
I have a set of Trinity wing buttons, I tend to use. I haven´t seen the originals yet.
Send me Your address in a PM and I´ll send You the One way plastic hubs.

-Dennis

[Neils74]

A lovely job well done, looks like we are at about the same stage.
Have you had any luck finding rear wing buttons, Im nearly getting to the point of buying a lathe and making the damn things myself.
Please let me know how the penguin shell works out, I did read that somewhere that they ran a little thin in parts of the moulding.

Thanks -
I have a set of Trinity wing buttons, I tend to use. I haven´t seen the originals yet.
Send me Your address in a PM and I´ll send You the One way plastic hubs.

-Dennis

Cool, Thank you ever so much. PM sent.

[kink]

One of my mates used to run the SWB, then the XL CAT. I remember he had a real pain trying to build and set it up correctly.

[Neils74]

A massive thank you to the parts that turned up on my doorstep today. Thank you!

[DennisM]

You´re welcome - glad to help out.

[DennisM]

Inspired by CAT3K´s freshly painted XLS, I decided to paint mine this morning.
The Tekin stickers was not applied because I dipped my fat fingers in the fresh paint, nope!

This mould could be one of a kind, it must be impossible to deviate from the centerline so seriously again.
I can´t remember which make the body is, but I was extremely happy with it when I bought it 6-7 years ago.
The enthusiasm faded a bit, this morning, when I tried to mask it, I had big plans for the "hood", but it didn´t look all that fresh with the scoop out of center.

So I ended up with this - No one will notice the bad mould - I drive like a rocket!...... Almost.

[Typpo]

Nice subtle window trim. What did you use for masking?

[DennisM]

Thanks -
I used Tamiyas yellow masking tape.
It was my first time masking with no bleeds, even though I´ve used the same tape before.