48 pitch conv on ol 6 gear tranny

[OldSkoolRC]

Howdy
Looking for a diagram or instruction for the 48 pitch gear internal conversion for the old six gear. I think MIP made it but I could be mistaken. Trying to breath life back into an old friend. Thanks

[THUNDERSTRIKE1]

Ive been tryn to find a diff gear 48 pitch for mine with no luck.Have everything but the diff hubs and the one gear.Don

[scr8p]

Build it the same as you would a stock 6 gear. The only difference is the gear pitch.

[Phin]

Thorp made them not MIP.

[flipwils11]

I have the complete thorp 48p setup and the outdrive bearing mod (with inner bearing removal from outdrives) in my red pan/American flag rc10 build. There are faqs on it in the temple tech section if you search.

[Rusty-Racing]

You can also use robinson racing spur gears as well I believe

[OldSkoolRC]

Build it the same as you would a stock 6 gear. The only difference is the gear pitch.

If that is the case Mine must have had some hop-ups that I forget adding since there is a series of washers and an actual bearing on the diff shaft in between the two top gears internally. That is where I think I goofed the order.

[OldSkoolRC]

You can also use robinson racing spur gears as well I believe

That's what it has on there now

[OldSkoolRC]

I have the complete thorp 48p setup and the outdrive bearing mod (with inner bearing removal from outdrives) in my red pan/American flag rc10 build. There are faqs on it in the temple tech section if you search.

Cool I will look into temple tech thanks!