Typical 540 brushed motor bearing size?

[SMOKE-DOG]

What's the typical bearing size for a 540 motor? I had some old stock brushed motors busted open and the comms cut and I want to replace the bushings with bearings. I'm figuring they are all the same size.

[THEYTOOKMYTHUMB]

Not sure of the size, but if you place a brass washer between the bearing and the can no one will no the difference...







This post was for entertainment purposes only. I never cheated... with my driving it wouldn't have helped.

[THEYTOOKMYTHUMB]

I'm bored at work and found this thread after some searching. Obviously I can't speak for it's accuracy. Hope it helps.

http://www.rcuniverse.com/forum/m_9489896/anchors_9489986/mpage_1/key_/anchor/tm.htm#9489986

[SMOKE-DOG]

That helps, thanks.

[RichieRich]

I just replaced the bushings on some brand new Associated motors. I used the 1/8 x 3/8 x 5/32 Metal bearings from Avid RC.

http://www.avidrc.com/product/9/standard-bearings/58/18-x-38-x-532-Metal-R2ZZ-standard-bearings.html

[SMOKE-DOG]

I just replaced the bushings on some brand new Associated motors. I used the 1/8 x 3/8 x 5/32 Metal bearings from Avid RC.

http://www.avidrc.com/product/9/standard-bearings/58/18-x-38-x-532-Metal-R2ZZ-standard-bearings.html

Sweet.