RC10Talk - The Net's Largest Vintage R/C Community

Just for reference, some info on the team spec Demon ProKing i have in this car.....following a health check and a rewire by bluewormx. What is interesting here is the six FET Demon ProKing which was built for Rory Cull. Instead of the usual 8 x BUZ11 FET configuration (240amp total) this lightweigh...

Starting to look like it: https://hitecmods.kuvat.fi/kuvat/RC/Marui%20Hunter/Hunter%20v5.png/_medium.jpg https://hitecmods.kuvat.fi/kuvat/RC/Marui%20Hunter/Hunter%20v5_1.png/_medium.jpg There are still couple of things in the chassis that need to be addressed, but those are small details. Parted the...

Working from home still so I walked down by the frozen lake on lunch. The ground is like mush from all the snow melting. 2 weeks below zero and 60 today. Feels great out!

Somehow, this just seems appropriate.

Everything lines up: https://hitecmods.kuvat.fi/kuvat/RC/20210224_135606.jpg/_medium.jpg https://hitecmods.kuvat.fi/kuvat/RC/Marui%20Hunter/20210224_140033.jpg/_medium.jpg And heres the first proto of the 2 piece chassis: Joined together with 4 screws under the radio box: https://hitecmods.kuvat.fi/...

Chassis is back from powder coat this morning. Time for the fun stuff to begin now and start final assembly.

Here goes a full rebuild of this pretty special Mugen Super Sport. It comes with these steel arms. I have never seen them before but I have read that the factory had built and tested with them. I don't believe this buggy was ever run. It was started, or at least attempted, by the starter wheel scuff...

Could someone more experienced with the Hunter/Galaxy list all the known most common weak points in this chassis? I already know the rear suspension mounts, the front hinge pin areas and the idler shaft slots, but is there more? Because when i look at this original chassis that i have, i have pretty...

Still hope. I have a couple days to catch up..

Everything lines up, except the idler axle hole thats in the motor mount metal plate (this was expected). I added set screws under the idler axle slots, just in case if my gear lash isnt correct, so i can adjust it and measure the amount of set screw thats visible. Seems that its not needed as the s...

Hi everyone,

I've found wing buttons in a few places, but having a hard time finding the actual wing wire... anyone know of anywhere I can find one, or a viable alternative?

Also curious what the consensus is on bodies... Sabula or TBG?

It's for this little number...

Does anybody have an information about these Vintage 834B Aluminum wheels?
They are very well made and would really like to know who made them.
Thanks!

Pic (not my car)

This may already be here somewhere but I haven't stumbled across it.

I was looking for information on my MIP bellcranks and came across this:

http://www.toybaron.com/MIPreference.htm

I thought it was cool. Enjoy.

This is the REAL DEAL folks. An all original Hotshot beater that my brother Derek (coxbros1) and I purchased off ebay and restored. It is a great runner too, not just a shelfer. Be sure to check out the fuctioning heat sinks that we all remember burning the hell out of your fingers and the Tamiya vi...