question

Post by **scr8p** » Mon May 19, 2008 8:29 pm

an rc10t rear shock tower, and a rc10gt rear shock tower. are the 2 lower mounting holes in the same position? more or less, i want to mount a gt tower on an rpm 10t bulkhead. thinking about it, anyway....................

Post by **shodog** » Mon May 19, 2008 8:41 pm

Composite craft marketed the same shock tower for both trucks. However I needed to drill holes in my chock tower to fit it to an RPM bulkhead.

Post by **scr8p** » Mon May 19, 2008 8:50 pm

shodog wrote:Composite craft marketed the same shock tower for both trucks. However I needed to drill holes in my chock tower to fit it to an RPM bulkhead.

the bottom holes? i know you need to drill 2 new uppers.

Post by **bscotti** » Tue May 20, 2008 11:47 am

I believe the bottom 2 holes are the same, but I'm going off memory. I was test fitting the same combination of parts.

Post by **GAMMACRUSH** » Fri May 30, 2008 5:22 am

i used a GT rear tower on this 10t. the two bottom holes lined up, but they are slightly off. just a very small amount, i had to put the screws in at a slight angle.

Post by **GAMMACRUSH** » Fri May 30, 2008 5:22 am

GT tower, bottom holes:

Post by **GAMMACRUSH** » Fri May 30, 2008 5:40 am

10t tower, bottom holes:

peace, gamma

RC10Talk - The Net's Largest Vintage R/C Community

question

question

Re: question

Re: question

Re: question

Re: question

Re: question

Re: question

Create an account or sign in to join the discussion

Create an account

Sign in

Who is online