Houge and/or A&L ball bearing steering question?????????????

[Dr. Robotnik]

Hi guys,

I found I had some Houge sealed bearing servo saver steering arms (which I believe are the same as A&L) and I was wondering, as this is all I have, if someone could tell me what else I need to make them work?

I used to have an A&L but sold it a while back and can't remember. If someone could tell me the bearing sizes, is that all I need? I don't need any collars to go with them do I? A close-up picture of one would be great (I am sure someone has one in a thread here they can direct me to)!

Thanks a lot in advance...

Cheers

Ed

[scr8p]

you'll need 4 1/4" x 3/8" flanged bearings. same as the rear rc10 hub carrier. this is the best i can do for a pic. you can kinda see the collars. the houge kits are the same way. as are the worlds bellcranks.

[Dr. Robotnik]

Thanks a lot for the info. mate Your pic has also reminded me I deff. need some collars to go between the bearings and screws....I wonder if those are in my parts lot somewhere?????!!!!!