It is a B stamp chassis that has been drilled and stripped. The thing that made me want it was the turnbuckles and the RPM stuff(arms,bumper and trans case all in white).I plan on stripping it and cleanining it and maybe re-anodizing the...
Last post
I was going to start breaking down the truck to start cleaning. Then I started messing with all my spare parts and built a whole buggy. :lol: :lol: :lol: I'll post pix later it should be another good project.
After looking for some time now, I finally came up on some RC10T's:
10Ts2.JPG
10ts.JPG
Not too much to look at right now. One has 4 extra holes drilled in it for the servo :roll: That's gonna be the runner. The other chassis is scratched up...
Last post
i wonder why they dont sell the molds on ? better than destroying them
Not by me.
I got an email flyer from liquidrc.com about their cheap shipping promotion. I put jrx into the search(it is quite slow) just for kicks, and came up with a bunch of neat stuff. gear adapters, 48, and 64p direct fit gears and some other...
Last post
The spur adapter would be nice for those who run their cars on a regular basis. Use any of the newer style spurs....
Found some good stuff digging in some old boxes at a LHS. Thought I would show some of some. :D
The rims are front regular width and the rear are 2.0 RC10.
I am working the next project out.
Last post
I have an identical set of rear associated rear wheels like thoes, only mine came white.
I was watching a NIB Optima belt conversion go through the roof at over $200 recently, but I jumped on this parts lot pretty quick. The seller actually had a Best Offer on it, I submitted a $40 offer...but after a closer look at all the parts, and a...
Last post
Good catch-I didn't even see that auction. That reminds me of the Optima Mid LWB conversion kit going for about $300. I guess it pays to shop around once in a while...
I saw this lot of Optima aluminum parts on eBay with only one bid of $4.99 and 59 minutes remaining...of particular interest was the front skid-plate, which appears to be in good, un-bent condition...that alone would probably be worth at least $20...
Last post
Nice grab Marc. Hope those rails are straight. :D
I've never seen bent frame-rails...but stripped-out 2.6mm threads, oh yeah...
I got a 10T coming in with a bunch of crusty white rpm parts on it. What is the best way to clean these parts? I know the peroxide bath is out of the question. Any and all ideas would be appreciated.
Last post
I use a solution of warm water and clorox kitchen/bath cleaner...very diluted. And a ton of elbow grease...
