New here, have a JRXT shipping to me

[y2kgtp]

Nothing exciting....just did a 2nd application of Sandable epoxy after I sanded down from the first round. Watching it cure over on a table here....

watching....

yes, that is a auto light used for discharging that snuck into the photo too.....

[bearrickster]

Its looking good!

[y2kgtp]

I had to redo that chassis....the epoxy would heat up when sanded, and would wear away. I am redoing it with JB weld. Sands much nicer.

I really did not look at the other parts of the truck, before I tore it apart, just got the parts off the chassis, and put the suspension in a box.

Well, I was going to start cleaning up some parts.....







I think I need a new front & rear bulkhead, and a front shock tower...

[bearrickster]

I have some used rear ones here are new fronts

http://cgi.ebay.com/TEAM-LOSI-A1003-NXT-GTX-FRONT-BULKHEAD-2-NEW_W0QQitemZ110296825558QQcmdZViewItemQQptZRadio_Control_Parts_Accessories?_trksid=p3286.m20.l1116

[y2kgtp]

I have some used rear ones here are new fronts

http://cgi.ebay.com/TEAM-LOSI-A1003-NXT-GTX-FRONT-BULKHEAD-2-NEW_W0QQitemZ110296825558QQcmdZViewItemQQptZRadio_Control_Parts_Accessories?_trksid=p3286.m20.l1116

I got some front's I won on eBay (black) will see what they look like. You got a photo of the rear bulkhead? I really don't need new, just not full of holes

[bearrickster]

I am in bed I will try to get them tomorrow

[y2kgtp]

I am in bed I will try to get them tomorrow

Hey, no problem thanks for looking.....I should go threw this mess and see what else is wrong!

[bearrickster]

I may have a tower email me a list and I will dig it all out tomorrow [email protected]

[y2kgtp]

Here is a Chassis I got from Doc J33P that had far fewer holes I cleaned up a bit. I need to sand the other one down after I went threw it with JB Weld, and see what it looks like too.

I was thinking a clearcoat layer perhaps? Or leave it flat black....

[bearrickster]

It looks good like that

[y2kgtp]

It looks good like that

Thanks....I'll prob use it, but still working on the one with all the holes.....I want to see how good a job I can do with it.

[Doc J33P]

Now that is what I am talking about! Looks great! I am glad I didn't throw it away, lol.

[bearrickster]

thats the chassis I have been looking for what ever you do dont anybody through it away. if you do I am your trash can

[y2kgtp]

Now that is what I am talking about! Looks great! I am glad I didn't throw it away, lol.

Same here!

I am still waiting on some chassis parts to put on it. I am still working on the original chassis for grins, and I think I am going to
do a gloss black, or something a bit different to see how it looks......

I still need to work on my RC10 chassis.....some of the scratches are REALLY deep, taking alot of sanding to get them out.....

[94RC10GT]

i still have 2 complete jrxt's one with rpm a arm's all the way around and the other has rpm 5 link set up and rpm arms in front .. and 1 spare thats a part truck .... i bought all 3 in the early 90's for the dirt oval ...