Does anyone cut comms?

[RichieRich]

I have a few Reedy comms that need some TLC. I don't think any of the local shops have comm cutters anymore. Or does anyone have any recommendations on a lathe I can grab on ebay?

[Tim W.]

Look for a Cobra pro com 2000. I have one and it has been great.

[Eau Rouge]

Integy Zipp Mod lathe: best bang for the buck.

Hudy Tech Comm Lathe: best lathe for lots of bucks.



I've owned them both. I still own the Integy if that says anything.

[Brandon G]

+1 on the Integy...

[adam lancia]

A Cobra 2000 or an old Twister will fit the bill Richie. Grab a couple of new carbide bits and you'll be set.

[YZ-10]

I have a Hudy lathe with diamond tip, would do them for you, trouble is I am in UK

[Erich Reichert]

I have the automatic Hudy lathe as well as an old fantom which is made of one piece so its as square as they come. Its the same one that Todd from Putnam Propulsion uses.

Rich if you just need those cut up send them to me and I'll rebuild them for you.

[bearrickster]

Just pitch them!!!! go Brushless and never worry about it again Thats what I did and will never go back best 150.00 I ever spent

[clinehobbies]

What's a comm?

[tecnica2001]

It's a motor communicator, it communicates the brushes with the wire wind magnet thingy

[RichieRich]

What's a comm?

Bill, I hope you are just pulling our legs.

Yeah, I have two Reedy Ultra comms that need some love. I was thinking of just getting a used lathe to clean them up. I already have brushless power but I'd like to keep some vintage power in my Tekin and A&L conversion.

Erich, I 'm sending a PM.

[YZ-10]

Just pitch them!!!! go Brushless and never worry about it again Thats what I did and will never go back best 150.00 I ever spent

Part of the fun is pulling the motors apart to skim them