Special Project Codename EF209 - RC 1/12 pancar

[silvertriple]

The work is not over, yet : I still need to take care of the driver and the mirrors... And as well, finish the electronics installation (not yet done on this chassis).

[silvertriple]

1/12 driver is so small... I decided to cheat as I did not want to paint the face... The body is a Hunter driver body scaled 80% and the the helmet is the one I did for the Super Wheelie, scaled smaller than 80%... Not sure how much I scale it down, but it is small.


The driver is in the car now...

[silvertriple]

As mentioned earlier, I have many plans for this chassis in terms of bodyshell...
And by the way, if you build one chassis for you, and work out a bodyshell adaptation you are putting on makerworld, let me know so I can add a link into the dedicated pancar 1/12 collection

I started to work on the Ferrari 312 bodyshell... This one may be red .
As we are dealing with endurance cars, lights is a must, and some 312 had central additional lights, so I plan for it (not sure if I'll use them or not, but it will be possible).

The rear bodymount is a variation of the one I made for the 333 bodyshell...

I printed those in TPU.




I still need to work out the rear end, as I'm not sully happy with this...


Once the parts under the bodyshell are done, I'll work out what is on top of it...

[silvertriple]

I spend some time over the week-end to work on this bodyshell... It's not perfect yet and still requires some minor improvements... I finished the part under the bodyshell...


As last time, I printed something to help the arch cut at the rear (on the front it is not needed on this Sabula Tech bodyshell)


And once this was done, I made a mirror and a roll bar...


It still requires a bit of work with some adjustments here and there, but we are getting there...






Soon it will be time to deal with the next bodyshell (teaser : Porsche 917K)