rc10 GT engine question

[GoMachV]

I'm going old school on mine, a real MADE IN THE USA K&B .18 engine. They are available from Mecoa and I have a machined head coming for it since mine came with the sport head. The pull start fits the non pull start mounts perfectly, but needs a pull start header which is a hard part to find currently.

This one comes with the better head....
https://www.mecoa.biz/shopdisplayproducts.asp?catalogid=2213

weirdest ordering process, but fast to process and ship.

[Garage Hack]

I'm going old school on mine, a real MADE IN THE USA K&B .18 engine. They are available from Mecoa and I have a machined head coming for it since mine came with the sport head. The pull start fits the non pull start mounts perfectly, but needs a pull start header which is a hard part to find currently.

This one comes with the better head....
https://www.mecoa.biz/shopdisplayproducts.asp?catalogid=2213

weirdest ordering process, but fast to process and ship.

That is awesome! Appreciate that tip and Link! Can I take a dremel and polish the edges of that black head to get the bare machined look or is that a different process

[RC10th]

Just get some reasonably fine sandpaper and lay it on something flat like glass or melamine or wrap some sandpaper around a flat stick/block and sand the edges. Once the anno is removed give them a light polish and your set.

[Garage Hack]

Just get some reasonably fine sandpaper and lay it on something flat like glass or melamine or wrap some sandpaper around a flat stick/block and sand the edges. Once the anno is removed give them a light polish and your set.

Great, thanks for that! I will give it a shot.