Aluminum Rear Arms???

Post by **PBR Allstar** » Fri May 30, 2008 11:52 pm

I'm wondering what the story is on Aluminum rear arms for an original rc10? I know I've seen some before, but can't remember where (maybe on some of the older bart's sprinter's?). Anyway, I'm looking for some for a shelf queen (well, I might run it a little

RC10 terminator I'm building from an older NIP kranzel's kit I picked up recently. Maybe tulsa or scr8p will have an idea on this one?

thanks,
ford.

Post by **scr8p** » Sat May 31, 2008 12:00 am

scroll down.

http://www.rdent.com/sprint/sprintparts.html

Post by **PBR Allstar** » Sat May 31, 2008 12:18 am

Ha! did I call that one or what! I remember seeing the R.D ent page before a while back, now that I needed it I could not figure it out for the life of me!

thanks

RC10Talk - The Net's Largest Vintage R/C Community