RC12L and RC10L aftermarket axles and spur

Post by **80sRunner** » Thu Jan 14, 2021 12:33 pm

Greetings,

I have a few aftermarket pan axles that do not have the "seat" for the spur gear. Is there some kind of spacer that should be used to center it on the axle? The OEM ones have the area where the spur seats in the center. All these axles use standard diff rings, but do not have the spur seat.

Thanks!

Post by **XLR8** » Thu Jan 14, 2021 1:42 pm

I think these axles were meant to be used with a 1/4 x 3/8 bearing for the spur.

Post by **80sRunner** » Sat Jan 16, 2021 12:53 pm

Just to confirm, this is an 1/4 x 3/8 x 1/8 (R168ZZ) non-flanged bearing?

Thanks!

Post by **ELF-BMX** » Tue Jan 19, 2021 11:05 am

80sRunner wrote: ↑Sat Jan 16, 2021 12:53 pm Just to confirm, this is an 1/4 x 3/8 x 1/8 (R168ZZ) non-flanged bearing?

Thanks!

Flanged is recommended but i dont think it necessary.

Post by **GoMachV** » Tue Jan 19, 2021 11:20 am

Bearing in the spur is unflanged. The axles bearings are flanged.

Post by **ELF-BMX** » Tue Jan 19, 2021 4:21 pm

GoMachV wrote: ↑Tue Jan 19, 2021 11:20 am Bearing in the spur is unflanged. The axles bearings are flanged.

I meant to type “un” in front of flanged,

. God damd spell correct.

RC10Talk - The Net's Largest Vintage R/C Community

RC12L and RC10L aftermarket axles and spur

RC12L and RC10L aftermarket axles and spur

Re: RC12L and RC10L aftermarket axles and spur

Re: RC12L and RC10L aftermarket axles and spur

Re: RC12L and RC10L aftermarket axles and spur

Re: RC12L and RC10L aftermarket axles and spur

Re: RC12L and RC10L aftermarket axles and spur

Create an account or sign in to join the discussion

Create an account

Sign in

Who is online