RC10T - Purple Modern Build

[Lavigna]

Few updated photos.

[firebird1999us]

Maybe I missed it - what shocks and springs are those?

[abailey21]

B5/6 Kashmia with J Concepts collars and caps

[blk05wrx]

Nicely done! Looks awesome.

[Lonestar]

Very, very, very nice and tidy

[Lavigna]

I made some finishing touches to the truck. I added the following.

- New 3 piece skinny front wheels and new rears. Dyed black
- New RPM rear bulkhead
- New RPM inner rear arm mounts
- New RPM rear over sized bearing hubs
- New black anodized aluminum chassis screws to replace the yellow/green stock pieces

After I took these photos, I altered the shocks so the Andy's body sits lower on the chassis, and looks correct. I will have to take a few more photos to show it. This thing is now pretty much done. I don't think there is anything more I would want to do to it. In person, it is so cool looking. I wish I could capture that better in the photos.

[Lavigna]

The site is not allowing me to post the remaining photos. I will try again later.

[klavy69]

The site is not allowing me to post the remaining photos. I will try again later.

the story of the new board setup...

Todd

[EMC]

What bellcrank parts are those?

[jwscab]

they are probably houge. the factory worlds style bellcranks would be the same roughly speaking. notice they are in the forward position so they are the buggy ones.

[Lavigna]

What bellcrank parts are those?

They are A&L. Dyed black.

[Lonestar]

- New 3 piece skinny front wheels and new rears. Dyed black

Tar and feathers!!!

But I have to admit the end-result looks jolly good!!!!

[jwscab]

Whoops...my bad. I didn't see the draglink in all the black.

Love the build!

[klavy69]

Whoops...my bad. I didn't see the draglink in all the black.

Love the build!

don't feel bad...I studied all the pix after you answered on a decent sized monitor at home and I never seen the draglink in all the black either

Does look good though

Todd

[DaveM]

Would have to be my all time favorite 10T build!