B1M bolt-in mid motor conversion kit

[DaveM]

Nice work Brian!

[mk-Zero]

Last night I printed the tower I designed and put it, along with the newest trans case and bulkhead versions on the car. Thanks to Jeff for the tower model, which I was able to modify to fit my bulkhead. So far so good!

[GoMachV]

Looking awesome Brian!

[Bottom Feeder]

Looks great. Are you building this around having an arms-forward short-wheelbase for any specific reason?

[mk-Zero]

Looks great. Are you building this around having an arms-forward short-wheelbase for any specific reason?

I don't think there's anything I'm doing that would prevent it from running in LWB. I'll test it out some time though since you brought it up.

[tiger1]

absolutely stunning and awesome!!!!!!!!!!!!

[finman]

Any updates - been waiting patiently

Rich

[mk-Zero]

Sorry, no progress recently I've been sooooo swamped I haven't had time. Maybe soon I'll pick it up again, it's fairly close, just need to iron out some details.

[Headling]

Any updates Brian?? I have a nice fresh powder coated chassis begging for this conversion!!

[mk-Zero]

Unfortunately, no

If it makes you feel any better though, I looked at it on my bench the other day and thought, "Man, this thing looks cool, I need to finish it up!"

I hope to wrap it up this winter

[Headling]

Good man! Get it finished and strap on some tyres and go race it!

I'm sure it'll go great, my laydown yz2 RC10 goes very well on turf

[durb69]

very nice work Mr!

[GoMachV]

Brian, when your ready for motor plates get ahold of Durb. Derrick does very nice work!

[blubblood]

What's the status on the bolt-in laydown trans project? I'm nearing the end of a mid-motor build with a Trackmaster belt drive, but I'm leaning towards using a Stealth trans instead and a laydown would be even better. Is your trans case an off-the-shelf part or custom printed?

Thx.

[durb69]

Brian, when your ready for motor plates get ahold of Durb. Derrick does very nice work!

Here I am just browsing RC10talk for the first time in months and I stumble over this as I was just about to PM the guy telling him I can make the plates for him lol. Thanks!