I have a GT setup with CVDs. I don't like them. One was clicking and its apparent they don't last like quality dogbones.
1. I popped out the CVDs and the RPM hubs have larger (frozen) bearings, I don't have new ones.
2. So I popped in the stock hub, bearings, stub axle, dog bone, axle pin, and pop on the turnbuckle.
...NOW THE DOG BONE IS TOO SHORT.
The rear arms are stock length.
What's going on here?
Need some RC10GT CVD assistance.
- GoMachV
- Super Member
- Posts: 11376
- Joined: Sun Apr 29, 2012 10:31 pm
- Location: Twin Falls, ID
- Has thanked: 838 times
- Been thanked: 2501 times
Re: Need some RC10GT CVD assistance.
Usually cvd's wear due to lack of lube
With the dogbones did you use the spacer and spring? They are required
With the dogbones did you use the spacer and spring? They are required
It's time to stand up to the bully. Support the companies that support the industry, not the ones that tear it down. Say no to Traxxas
Factory Works website
Factory Works website
Create an account or sign in to join the discussion
You need to be a member in order to post a reply
Create an account
Not a member? register to join our community
Members can start their own topics & subscribe to topics
It’s free and only takes a minute
Sign in
-
- Similar Topics
- Replies
- Views
- Last post
-
- 2 Replies
- 910 Views
-
Last post by funbags
-
- 5 Replies
- 261 Views
-
Last post by GreenBar0n
-
- 16 Replies
- 4236 Views
-
Last post by JK Racing
-
- 4 Replies
- 961 Views
-
Last post by Hcp22
-
- 16 Replies
- 2048 Views
-
Last post by Russ Winn
-
- 6 Replies
- 2077 Views
-
Last post by Coelacanth
-
- 2 Replies
- 959 Views
-
Last post by RC104ever
-
- 20 Replies
- 4115 Views
-
Last post by jwscab
Who is online
Users browsing this forum: Ahrefs [Bot] and 17 guests