Procat/Bosscat prototype...

Post by **Peakey** » Wed Nov 26, 2014 1:28 am

There nice

Post by **Jay Dub** » Wed Nov 26, 2014 6:27 pm

Sweet!, the plastic ones on the car are really close to those. The production pieces have two holes per piece, and a flattened area for the servo. Th plastic one from the car look like a production version of those (see pics). Thanks -J

Post by **Asso_man!** » Thu Nov 27, 2014 8:25 am

Looks very similar and probably an evolution of this one, note the TopCat front upper wishbones! Carbon fiber weave pattern from the chassis looks very similar to yours.
The car below was run at the '91 Worlds in Detroit, I assume by Kevin Moore but could be wrong.

Post by **Jay Dub** » Thu Nov 27, 2014 12:18 pm

Cool, thanks for sharing. Yeah the chassis looks to be Fyberlyte to me. Many of the parts on that car look similar to the one I have. It is about half rebuilt. Maybe this weekend I can post pics of the cleaned up car as I received it.

Post by **Jay Dub** » Fri Nov 28, 2014 3:24 pm

Ok, well had time to finish it today. At least what was included with the car. I did take two liberties though: 1) I built the car with all new metric hardware (where applicable), and I added period correct wing mounts. I know the car had wing mounts similar to what I have mounted because of the existing holes in the shock tower, and the marks on the tower from them being previously mounted. Not sure what I want to do with it now. It would still need a few parts to finish, rear shocks and tie rods, body and under tray (if I took it that far). Enjoy, -J