Associated RC10 Stealth Mounting Jig/Template

[teman]

Here's the scan of one of the original jigs and the template I drew from it. Feel free to use it if you wish at your own risk for personal non-commercial use. The jig itself is not for sale sorry.
-Kevin

stealth jig scan.jpg (27.55 KiB) Viewed 2797 times

stealth jig scan.jpg (27.55 KiB) Viewed 2797 times

stealth jig.jpg (35.46 KiB) Viewed 2797 times

stealth jig.jpg (35.46 KiB) Viewed 2797 times

[Asso_man!]

How much do you want for the jig? PM sent!





, maybe we should put it in the scan section?

[teman]

I didn't know where to put this thread. You guys can move it if you like.

I figure most can use this without a problem. I DID spend quite a bit of time drawing this as accurate as possible using a drawing program and in millimeters, so as long as people know what bits to use and drill where the +'s are, you're good to go.

If someone knows what bits are best for the stealth and what countersink to use, please post. I read it somewhere on here, but I don't remember what it was exactly to repost that info here.

haha and no, I'm not selling the original jig

[jwscab]

they are #4-40 screws, so a close fit hole is a #32 drill, or somewhat looser will be 1/8". Countersink is 82 degrees.

BTW, how much for the jig?

[wait a minute]

Just by eying the template looks pretty close to me. Nice job.

[GodSpeed]

When I print it, it comes out like it's for a 1/5 scale car. Any ideas, or trial and error for reducing the size % ?

[teman]

I think your printing "fit to printer margins"? I sent you a PM too.

[GodSpeed]

I think your printing "fit to printer margins"? I sent you a PM too.

Well I was printing it via my iPad so that could have definitely caused the problem, but the .pdf you sent me worked perfectly (printing from iMac) so I really appreciate it.

Thanks.