Asr09's Worlds Re Re Racer

[Asr09]

[GodSpeed]

A lot of nice things going on there.

[Asr09]

Here's the setup details:

Novak Edge 10.5 system

JConcepts steering and motor plate

Lunsford turnbuckles with TC6 turnbuckle eyelets (ASC31305)

RPM rear arms and gear cover

Futaba S9551 servo and R204GF-E receiver

I tried to go with as many black plastic parts as I could find. I plan to dye the bulkhead and tranny case.

I machined the brass weight myself. It's approximately 38g (1 3/8oz). Time will tell if it hurts or helps.

[pumpkinfish]

Did you use the kit ball studs with the TC6 turnbuckle eyelets (ASC31305)?

[Asr09]

Most of the ball studs are from the kit, but I used a few of the broached studs (used on the B4) here and there. I measured the difference between the two, and found it to be about .001" with the kit studs being slightly smaller.


Closeup of the front end: