RC10GT captured CVD?

[funbags]

Hey guys,
I'm new to this forum and this seemed like the perfect place to get some answers. I picked up a 10GT roller a few months back, and a few weeks ago I upgraded to an OS 18CVRX. I love that engine, wheelies on command. The only catch is that I've managed to bullet proof everything except the MIP CVDs. The damn pivot pins always walk away, just when I'm having fun. I usually get a few tanks of fuel and then, boosh, pins disappear.

Is there a captured CVD for an other AE model that would work on a 10GT? I searched the site but couldn't find a post that covered this question. This is driving me nuts.

Any help would rule.
Thanks,

[klavy69]

you can get either cvd boots or put some shrinkwrap over the bell and trim it down after shrinking...

I've used both ideas and wore out cvds before losing pins.
Todd

[funbags]

Brilliant! Thanks for the tip. I'll try the shrink wrqp while the boots are in the mail. Thanks so much. This is just the thing I'm looking for. This forum kicks the proverbial butt.
Cheers,