m-chassis (M-05) pinion stopper

[tim.sanderson]

I was given a very dirty/beat up M-05 pro last weekend. I'm almost done rebuilding it, and putting in the electronics. I don't have a pinion stopper to properly space my pinion. The older m-chassis' had an opening on the other side of the motor, but the m-05 does not, so I can't just eyeball it like I normally would.
If someone would be a lamb, and measure one if they have one? I'm looking for the distance between the arrows:

Thanks!

[Mindwarp]

Metric and inches. I'm assuming you want the measurement that is from the base to the inside of the top. It's a bit tricky to measure but it's 17.5 mm or 0.7 inches.

[tim.sanderson]

Excellent, thanks!

[Mindwarp]

No problemo!

[tim.sanderson]

Not bad... the caliper is set to 17.5mm, and the pinion is on the motor were I guessed it should go before you sent the measurements.

lucky guess.jpg (25.6 KiB) Viewed 1042 times

lucky guess.jpg (25.6 KiB) Viewed 1042 times

[Mindwarp]

We'll have to start calling you "eagle-eye".

[tim.sanderson]

Here's the chassis so far. Not bad for a freebie, huh?

[Mindwarp]

Nice! I'm digging the shocks as well!

[Mindwarp]

Here's my M-05 with a Honda body.