I just got a set of narrow front wheels for my 10T. Is there supposed to be one or two bearings in there? only asking because the inside hole is larger than the outter...
metallicats33 wrote:I just got a set of narrow front wheels for my 10T. Is there supposed to be one or two bearings in there? only asking because the inside hole is larger than the outter...
Was your problem solved?... was it the bearing size?
Are there any new/modern tires out there that will fit the early narrow rc10t rims? I would like to try out the narrow rims but I do not want to use the narrow AE tires I have since they don't exactly grow on trees. I think I remeber reading about...
Last post
Jconcepts J82 fronts are perfect fit..........and on closeout at Jconcepts.net :wink:
JC Racing have just released their 2.2 narrow front 870C/YZ10 front wheels, so you can now buy 870c/YZ10 rears as a pair and these as a pair for your TH-1 equipped pre T2 RC10 👍
Last post
I got a set of their new RC10 B2 2.2 wheels with narrow fronts recently. They look really good but the front bearings are really sloppy in the wheel. :(
Could the poor fitment in the wheels be a case of mixing millimeters and inches on the...
ok i have some narrow front 2.2 wheels on my rc10 project. i have been looking around and haven't found much in the line of tires for the narrow wheels. i ended up ordering a set of panther lynx ribbed front tires to try out.
they are listed as...
Last post
horizon used to have quite a few narrow losi front rib tires in a couple different compounds. don't know if they still do or not.....
Where the tires that came with the 10t kits the same as the buggy front tires? Does anyone make a similiar wheel? Are the same as a current buggy wheel?
Last post
I'd give those wheels a soak and see if they were intact - a lot of folks 'flattened' them to accept foam but who knows until you have a look at the complete wheel. Acetone or lacquer thinner should take care of any glue holding the foam!
Has an aftermarket manufacturer ever made a front arm set that was the same size as the original front arm set? I want to do some hopping up to my graphite car requires narrow arms for the MIP 4wd kit.
Was there a such thing? Looking at RPM and Andy's, I am only seeing what look to be wide front arms. Any options?
Last post
I think there are alloy sprint car options out there also. I've got a set of Barts somewhere around here but not sure of their exact measurements. Hot trick had them also along with a few other blingey type brands. The names aren't coming to me...
I had mistakenly ordered several set of the narrow JC Racing front JRX-2 wheels and I am finding it difficult get get a set of ribbed tires to mount correctly on them. At least the HB ribbed tires I purchased. Is there a set of narrow ribbed tires...
Last post
If you are set on ribs, you might be able to stretch a vintage tire on.
Otherwise, Proline and JConcepts have some narrow tires.
I've heard that some people have cut down the inserts of a standard tire, and that allowed them to be mounted on the...
Has anyone ever created a narrow X2 bulkhead that would allow a long arm Jrx2 build with the LXT front arms? Sort of like the what's old is new RC10 builds that run 10T front arms? I imagine narrowing a graphite chassis plate for it to bolt too? I...
Last post
Looking at the pic of Nitro Hawk that is basically it indeed. I'll get working in a couple weeks. Was used on TRX1 as well, part #TRA2731, I ordered a couple just in case they may even work with a little modification. They are cheap.