BBT questions WING MOUNTS

[Bent]

Not sure where this goes exactly but.......................


GOT A WING

[Bent]

I was also wondering what would be the best way to mount a wing to this roll bar, that will allow me some adjustability.

[DHood]

Most wings are 6x6 and the side dams can vary.

[Bent]

Thank you Hood, But I was wanting the stock deminsions on the Stock rc10wings.

[scr8p]

there's an associated wing for sale in the bst. you could buy it, then measure it. i'm sure slotcarrod would appreciate the purchase.

[Bent]

scr8p After putting 75.00 into a car I already own I am only able to build my own wings right now. I did see slotcarrod's sprint body and wings yesterday though. Any ideas as to what would be the best way to mount the upper wings to my cage so that I will have some adjustability?

[Bent]

I need to know what the best way is to mount the wing to my bbt sprinter. I need to moun it so that i can have some adjustablity

[shane]

IMO, I'd try velcro or similar because the need to break-away, if your going to run it.
sorry for butt'n in with my .02 (very nice BBT, by the way)

[Bent]

Ty Shane, but how would that give me some adjustablility??? I have the back figured out I just need to find a good wa...................Ty Shane I think you just figured it out for me.

[shane]

[scr8p]

i'd put a hinge at the front, and then make some standoffs for the rear with multiple holes so it can be adjusted up or down.

by the way, that's an ascot cage, not a bbt.