RC10Talk - The Net's Largest Vintage R/C Community

Here is an update to the diff, seems to work well in printed form

1) the best route with currently available parts imo is to move the FanRC diff to the front since our kit is designed around the older stealths (the rere wasnt around yet) and the wide FanRC diff won't fit the new AE case. Then grab the AE 6565 rear case and AE 6578 outdrives. You can use either Fan...

GreenBar0n wrote: ↑Tue Dec 17, 2024 2:41 pm Less than 3 hours from there. Hoping tomorrow is the delivery day

This time of year I trust a wet fart over any shipping company

Thanks for the heads up, I was on backorder and it wasn't fulfilled so I had to call and get it straightened out.

I've seen a few in recent times but I think the bulk of the regulars host here now after seeing what happens over time.
There used to be a feature where the pics would be automatically resized which was super handy. I post a fraction of what I would if that was still around.

This is not targeted at you, rather the usage of ai. If you are someone that doesn't want to communicate on a forum, why would you be here? Using AI to write what computers think about a situation brings nothing of real life experiences. If I wanted to know what Google thought about something I woul...

It's a 681xzz bearing, you can get them even on Amazon

Daryls son sent me some of his drawings recently and I finally know the material they used on our A&L wheels and trans cases back in the day

Im sure modern materials have advanced, but back in the day Daryl said they would mold a few different materials and take the wheels out back to the dumpster and chuck them as hard as they could to see if they could get them to break. The material they ended up with was the one that survived the dum...

naw they just exaggerated wildly. Their FWD was the same way LOL

Lavigna wrote: ↑Mon Dec 23, 2024 5:04 pm My bearings arrived today in preparation for my Schumacher C2 Works build.

Do you have a pozidrive pz1? I broke down and ordered one, I feel like I need the full experience. My jis driver works but definitely not proper. Phillips just doesn't cut it.

I suspect the dirt master manuals were pieced together off the old rb5 as I have built many of the Kyosho Legendary series and the dirt master (as well as the dirt cross) manual is terrible in comparison. Not the worst, but not totally clear on some steps. The Shumacher method of one bag, one step i...

For the last Ten4.1 I decided to go a little different route by adding CC to the end of it 😉. The clear parts are just my regular ten4.1 parts but printed with a clear resin. The clear parts are not strong, but they will look great on the shelf. I may offer very limited numbers of the clear parts bu...

That might be the item you have held onto the longest, I'm honored usually it's on eBay by now.

The clear parts are straight off someone else's resin printer but then drilled and tapped as I was scared to self tap a screw into them. My previous experience with the clear parts was really bad, but these seem stronger.