RC10Talk - The Net's Largest Vintage R/C Community

Thank you Todd. Great advice. I'm really stuck on the white, as cool as the black still looks I gotta do the white thing. Maybe afterwards I'll build a full black car and have it going forward but I gotta experience it at least the once understandable Jason. Most everything I have I run so its one ...

Incredible_Serious wrote: ↑Sat Nov 17, 2018 3:44 pm

klavy69 wrote: ↑Sat Nov 17, 2018 3:36 pm

Incredible_Serious wrote: ↑Wed Nov 14, 2018 2:59 pm How did I miss this???

Alex

You've just been slacking Alex! Hell, even I seen this and I've been wiped out at work 68 hours a week on the low average

Todd

not trying to be anti hopup here but metal gears aren't the answer for these stealth boxes. You can go ahead and try it but give it a few runs and when you tear it up do your wallet a favor and go back to the original AE parts. They will last longer and be better on all the other moving parts but th...

Besides the standard stealth trans I second the A&L lethal weapon trans for what you after. I've run several of them over the years and they are easy to maintain and parts are readily available now that A&L has been revamped into Factory Works and is up and running again in Oregon.

Todd

Hi and welcome to the forums. I know the others didn't leave much for an example back in 2012 before you but asking for parts outside of the b/s/t area is not what we are about on this board. Feel free to browse the Forum Rules . If you have some pix of your Spirit FF feel free to post up a thread a...

Great build Al! one of my all time favorites and its earned its place at the head of the table!

Todd

.just gonna close my eyes and pick one I fall over to throw on here just to take a spot

P.s. warned ya!

Picked this up from a local a few years back including all his dirt and grime still attached...

Its definately got at least a 2 speed, i can see the cluthbell when i zoom in, and a .21. Some better pics of trans and clutchbell area... 1548020883554-1701795088.jpg I'm not an expert on anything IC but even I know a .21 3 speed in a 1/10 is overkill ! Until I read this I guessed it was 1/8 , I'm...

If you wanted them build them and put them on the shelf. Easy.

Todd

tires look like the proline razor backs. Not a big tamiya guy but maybe like a hornet or a frog wheel?

Todd

Thats a great start

For a little warmer thought... dammit...shows up regularly on my phone but when I post it shows up sideways

Halgar, I run synthetics in all of my daily drivers. I'm not one to get new vehicles unless they are needed. I generally end up scrapping my decommissioned ones but its because of just worn out drive trains vs. bad motors now. Once I started using synthetics it brought my average decommissioning up ...

That would be an HPI RS4MT. They were a belt drive 4wd truck that was brought into the era when nitro stadium truck was ki da ramping down but pre lipo and brushless major popularity. They had an inner body driver figure that kept dirt and debris out of the chassis with some of HPIs coolest truck bo...

wish I still had my black dyed one. Was after something other than black so I could go 80's colors but then dyed it black and had an offer I couldn't refuse thrown at me so its down the road now. I'm digging the pink. Too bad you didn't have any dylon florescent pink to freshen it up to completely 8...