After reading up on the Mirage and Mirage II bodies i started getting excited because i remembered my LHS having some old RC10 body in a bag on the far corner of the shelf.
Checked it out yesterday and it's a Deja Vu body.... part #6151 i think. It...
Last post
After reading up on the Mirage and Mirage II bodies i started getting excited because i remembered my LHS having some old RC10 body in a bag on the far corner of the shelf.
Checked it out yesterday and it's a Deja Vu body.... part #6151 i think. It...
I am having a serious case of deja vu and hoping someone might be able to help. Today after browsing through the Bay, I came across a listing with a car that just…I don’t know…I swear I have seen it somewhere before?
I thought perhaps it was from...
Last post
That’s awesome Lavigna!
RCCA must have really liked that body..they also put that painting article in the 1992 “R/C Car Painting & Finishing Techniques” special issue.
I've been looking for the shock rebuild kit #6440 and it appears to be quite rare.
Are there substitute shocks that can fit the RC10T?
I saw a set of V2 rear shocks. It says they're 1.39 but I think I have 1.32 currently. I'm guessing it won't fit.
Last post
I was thinking about directly replacing my Rc10T shocks out right with something modern and readily available to preserve my original T shocks. I tried the links for this build
But certain parts aren't available. I see proline has sets for short...
These seem like a fitting solution for the old skool cast steering knuckles on the optima and maxxum and mid. 5X10 mm bearings like the original.
Did anybody try this yet?
these are the hopped up versions (availablein different colours too)
Last post
I think I know which arms you are talking about roger: I have a set and had them on my optima mid and stinger projects. They did not stay on for long though: the front arms don't line up the steering knuckle with the diff outdrives.
This extends the...
hey guys, im not really a fan of the technacraft designs, does anyone have any alternatives?
buggy/truck/pan
I see plenty of well made (and cheap) crawler wheels, surely there are other classes available
Last post
i have a set for a b4. they are basically one offs made by a guy over on oople. he done 2 different styles. one style looked like basically like the stock wheels but in aluminum. the second style looked about the same except it had some small round...
I am looking for a replacement rear driveshaft (part #U1915) or alternatives for a CAT '98 runner. Replacements seem to be difficult to obtain though this part (along with U2213) was used on various models (CAT 2000 SE, CAT 3000, and Fireblade...
Last post
An explanation regarding alternative driveshafts (and hexes) can be found at the following links. Thank you to Discount RC Store, Incredible_Serious, MattW on the Schumacher forum, and Schumacher for their help along the way.
Hope this is the right place to post, I'm trying to find a replacement CVA/CVD set for my B4.2 and can't seem to find any in the UK. Every time I've ordered something outside the UK I seem to get stung on taxes or shipping is crazy expensive.
(I...
Last post
Ran it for all of 2 minutes Sunday. Seemed ok, until the pin popped out and the CVD bone fell off!
Rookie mistake, they come pre-assembled and I didn't check that the grub screw was done up tight.
Unless I can find a rebuild kit, then I'll go back...