RC10Talk - The Net's Largest Vintage R/C Community

Is there an generic alternate to, or cheap source of, BATTERY POWER CONNECTOR PINS 652 Team Associated?

Are they not just bullet connectors? From the 12L manual, it is hard to determine if they are specific pins for a plug or just bullets.

I assume you are asking about the motor connector. That is a simple AMPS 2 pin and can be found at Mouser, Digikey and other electronics shops.

https://www.digikey.com/en/products/detail/te-connectivity-amp-connectors/1-480319-0/15662

GoMachV wrote: ↑Tue Aug 09, 2022 9:26 pm I assume you are asking about the motor connector. That is a simple AMPS 2 pin and can be found at Mouser, Digikey and other electronics shops.

https://www.digikey.com/en/products/detail/te-connectivity-amp-connectors/1-480319-0/15662

I'm interested in the battery connector. It looks like a way to solder on bullet connectors to nimh cells. They look like they were used around the time of the original worlds and the t2.

Have you checked out valkyriercmotorsports? They seem to have the 652 bullet connectors.
Or a 4mm bullet connector set.

Chuck

radioactivity wrote: ↑Thu Aug 11, 2022 12:51 pm Have you checked out valkyriercmotorsports? They seem to have the 652 bullet connectors.
Or a 4mm bullet connector set.

Chuck

I didn't check there. Thanks for the link. Looking at the picture of the actual plugs I'm going to have to read up on how they attach to the cells.
These look to me to be the standard female bullet connectors which I already have in my parts box.

vs




The manual pictures aren't clear on what the solder connection looks like for the 652 connector. This is from the Worlds manual the T2 manual is slightly different.

JosephS wrote: ↑Thu Aug 11, 2022 2:28 pm I didn't check there. Thanks for the link. Looking at the picture of the actual plugs I'm going to have to read up on how they attach to the cells.
These look to me to be the standard female bullet connectors which I already have in my parts box.

The Reedy 652's in your pic show both male and female connectors in the pack.

jcwrks wrote: ↑Thu Aug 11, 2022 2:35 pm reedy_652_connectors.jpg

Seeing those instructs helps quite a bit. These appear to be standard bullet connectors.