Page 1 of 1
Ever use a Dhawk Metal Stealth Case?
Posted: Thu Apr 15, 2021 2:10 am
by guitronics
I was wondering if anyone has used a Dhawk Metal Transmission case?
How did it turn out, in terms of accuracy?
Was it a good choice of cases?
Re: Ever use a Dhawk Metal Stealth Case?
Posted: Sun Apr 25, 2021 11:10 pm
by klavy69
For the shelf it would be fine I guess. Mostly using original stealth cases for my runners...
Re: Ever use a Dhawk Metal Stealth Case?
Posted: Sat May 01, 2021 9:33 pm
by Faux4x4
I recently built one for my DS and it is smooth, I have not run it yet so I can not speak to longevity or wear on parts. I would assume it is not quite as precise as the small batch aluminum cases that have been made.
Re: Ever use a Dhawk Metal Stealth Case?
Posted: Sun May 23, 2021 8:47 am
by Skeetie96
I recently purchased the Dhawk metal case to replace the stealth on my Team Car. I was actually looking to just replace the idler gear because it had stripped the teeth on it. As I was looking for the gear, I found Dhawks aluminum case and decided to get it. Question: what bearings go in the case that hold the top shaft? I used the same size bearings that was in the stock stealth and I am getting a lot of axial and radial play in the top shaft. Something is different w/this case and I am not too familiar with the RC10 models after the team car to know what changed. Thanks!