RC10Talk - The Net's Largest Vintage R/C Community

RC10 GTM 2.0 Buggy (GT flat chassis+trans)

Finally got around to the RC10 Mid 2.0 with blue chassis instead of tub! Still waiting on the Kyosho Ultima rere.

Associated GT RTR chassis/trans
Associated RC10 Team Car suspension
Associated RC10 B6.1 battery holder

Kyosho ZX-5 lexan
Kyosho Turbo Scorpion roll cage
Kyosho Optima driver figure

Going to add B4 top shaft and fancy slipper, and diff rebuild.

Ironman Ivan Stewart paint

#weareae
#teamassociated
#rc10
#jconcepts
#proline
#aka
#hobbywing

The close up of the rear tower is to show the way I mounted a section of the Kyosho roll cage so the the cage could clip on.
The RPM ball cup have been replaced with Dubro. I like how they mount with screws instead of ball cups.
The roll bar is stock Kyosho Turbo Scorpion.
It is easy to make nose tubes with aluminum stock.
I want to put a B4/5/6 fancy slipper on as well as a maintenance session on the diff before going out racing with it.
I might play around with the rear shock mounting to get a good lean back on the shock.
Paint needs to happen.

Very nice, something different. I think it will have a cool look to it when its done.

Good beverage choice as well. Kanpai!

update:

Cool Build.

If you rotate the steering servo by 90 degrees, and Tuesday a shorter tie rod you can move the servo further forward to generate some space. I assume that is a low profile servo

Thanks,
I haven't decided how to mount the servo and the steering rack too.
It is low profile so I have more flexibility.

More progress.

245mm wide at front
249mm wide at rear
270mm wheelbase
3lb 7.4oz
1570g

RC10 GT MidMotor Buggy grabs 3rd out of 10 mod buggies, on carpet.

Nice!! Looks good out there! Driver is always the key of course. Nice work.

I’d call that a successful build and run congrats bud.

this is soo cool. Thanks for sharing your invention