Page 1 of 1
Lipos in a bosscat?
Posted: Thu Aug 27, 2015 10:43 am
by autoxvw
Anyone have any pics of lipos mounted in a bosscat? What did you use for straps/brackets etc?
Re: Lipos in a bosscat?
Posted: Thu Aug 27, 2015 3:35 pm
by Danf1275
I use Core RC stick packs in mine, in some 3D printed saddles to lift it above belt.
http://www.tamiyaclub.com/showroom_model.asp?cid=126136&id=41229
Purple saddles are just about visible. I swapped velcro ties for releasable tie wraps, as pack moved otherwise.
Re: Lipos in a bosscat?
Posted: Thu Aug 27, 2015 11:47 pm
by autoxvw
Where can I find those 3d printed parts?
Re: Lipos in a bosscat?
Posted: Fri Aug 28, 2015 10:13 am
by Groomi
I cut in half a cougar SV saddle lips cradle, used the existing forward position rear holes and drilled new front holes in the Bosscat chassis. I found the weight to be too forward bias, so will be moving them back and at an angle so the new front hole goes inwards of the cutouts.
Will try to find a pic...
Re: Lipos in a bosscat?
Posted: Fri Aug 28, 2015 10:53 am
by Danf1275