Asr09's Worlds Re Re Racer
Posted: Thu Aug 28, 2014 6:30 pm
RC10Talk - The Net's Largest Vintage R/C Community
Asr09's Worlds Re Re Racer
Page 1 of 1
Re: Asr09's Worlds Re Re Racer
Posted: Thu Aug 28, 2014 8:30 pm
A lot of nice things going on there.
Re: Asr09's Worlds Re Re Racer
Posted: Fri Aug 29, 2014 5:50 pm
Here's the setup details:
Novak Edge 10.5 system
JConcepts steering and motor plate
Lunsford turnbuckles with TC6 turnbuckle eyelets (ASC31305)
RPM rear arms and gear cover
Futaba S9551 servo and R204GF-E receiver
I tried to go with as many black plastic parts as I could find. I plan to dye the bulkhead and tranny case.
I machined the brass weight myself. It's approximately 38g (1 3/8oz). Time will tell if it hurts or helps.
Novak Edge 10.5 system
JConcepts steering and motor plate
Lunsford turnbuckles with TC6 turnbuckle eyelets (ASC31305)
RPM rear arms and gear cover
Futaba S9551 servo and R204GF-E receiver
I tried to go with as many black plastic parts as I could find. I plan to dye the bulkhead and tranny case.
I machined the brass weight myself. It's approximately 38g (1 3/8oz). Time will tell if it hurts or helps.
Re: Asr09's Worlds Re Re Racer
Posted: Fri Aug 29, 2014 10:15 pm
Did you use the kit ball studs with the TC6 turnbuckle eyelets (ASC31305)?
Re: Asr09's Worlds Re Re Racer
Posted: Sat Aug 30, 2014 9:04 am
Most of the ball studs are from the kit, but I used a few of the broached studs (used on the B4) here and there. I measured the difference between the two, and found it to be about .001" with the kit studs being slightly smaller.
Closeup of the front end:
Closeup of the front end:
