On the back-burner I have had this rc10 classic waiting... been grabbing cool stuff here and there and finally it was time to put it together! I love a kit... good times. Took me a little longer than I expected but I thoroughly enjoyed the build.
I really appreciated Jconcepts stepping up to this iconic RC and busting out some pretty cool stuff. The upgraded steering setup was a must. I couldn't help but pick up the carbon fiber goodies. Then they had these cool tubes braces and wing tubes that are square... and round. Picked them up! Of course there is MIP, my favorite upgrade for any vehicle is CVD's.
The transmission is what took me the longest. There was some play with the outdrives and top shaft... I couldn't figure it out and then it got later and later. I was listening to 70's rock so I don't know.... but that just seemed to drag on. Finally I put the motor plate on with the felt around the outdrives and everything firmed up. I have even taken it apart three times to double check, I haven't forgotten anything. I try to remind myself this was a kit from back in the day... so it is what it is. I picked up some bearings from Fast Eddy and made sure everything was smooth with Moo-Slick from COWRC.COM. Once I got everything together on the chassis I was going to call it a night... but the wheels!!! Chris from REC did these sweet mama's up and I had to mount them.
I couldn't go to bed without making sure the workspace was cleaned up so I packed everything away and grabbed these pics.
Then today went out with the family... first thing when we got back I was thinking about this custom lid I had made up. So I jumped in to mount it. This lid was unlike any other lid. It's a pain... that's it. But I put it together and of course sticker it up!
So this is where it sits... still need to pick out some electronics. Have a couple more goodies ordered up- some puretech mounts and strap. I saw this cool vaterra servo mount that would go nice with the aluminum swag I have going on. Speaking of aluminum... I missed REC launch of the aluminum transmission case for this. So I called up a buddy of mine and tomorrow I am shipping him my transmission, I am hoping he can come up with something.
So I also picked up some RPM rear and front arms for this. But when I tried to mount the rear arms the hinge pins are too short. I just eyeballed the front arms at that time and I backed off. Does anyone know if the rpm arms are compatible with this kit?
Let me know what you think and any advice is always welcomed!
