RC10Talk - The Net's Largest Vintage R/C Community

Model number 12156. Will it work? For some reason it is in the b3 section of their site, but the product figment says it's for the b4 and sc10...

Well, I just ordered one for cheap on ebay, so when it gets here we'll do some science.

that won't work in a b3 trans case. the stock b4 topshaft has a separate spacer that goes on the topshaft when used in a b4 case. to use it in any other stealth case the spacer can not be used. the mip shaft has the spacer built in, so you can't use it.

you have to use a stock b4 topshaft (9601 or something like that) to use a modern slipper setup on your b3.

If you're dead set on a MIP you can have a machinist turn down the shaft "built in spacer". I just did one last week, Its pretty simple

Thanks for the tip. I could probably figure it out and do it on my lathe