RC10Talk - The Net's Largest Vintage R/C Community

This has just been bugging me lately, With the nose plate mounted, the servo mounts are at 2 different heights, I can mount the servo w/o issue like this but it sorta bugs me that they are uneven.

Do yall ever do anything to counter that?

BITD they trimmed the nose plate to correct it

Or, as on the t2, placed a spacer under the rearmost one to raise it up to be level.

Chris

clm wrote:Or, as on the t2, placed a spacer under the rearmost one to raise it up to be level.

Chris

This is what I'm doing, just adding a washer under it.

Use the too-small spacers that they provided for the rear shocks.. I think that's what the t2 used actually

Chris

If it's a car I want to lighten up for racing, the nose plate will be cut, otherwise, I just slice a thickness off the bottom of the front mount:



Which I think is easier an cleaner than spacers.

DMAT wrote:

clm wrote:Or, as on the t2, placed a spacer under the rearmost one to raise it up to be level.

Chris

This is what I'm doing, just adding a washer under it.

The Classic manual calls for two #4 aluminum washers, seems to work fine.