RC10Talk - The Net's Largest Vintage R/C Community

Has anyone tried using the MIP CVD bones for a vintage RC10 with the B4 style cvd axle shafts to use modern B4 hex wheels? You could even use the T4 hex's to make it a little wider if you desired. Thought i'd throw this out there to see if anyone tried it before I shelled out the $40 to find out it didn't fit!

http://www.rc10talk.com/viewtopic.php?f=35&t=17844&start=30

This is the best work through to get B4 hardware on an RC10

Are not all b4 axles the same lenght outside the hub ? b4 to sc10 ? Self clamping b4 hexs should work no?

ck33 wrote:http://www.rc10talk.com/viewtopic.php?f=35&t=17844&start=30

This is the best work through to get B4 hardware on an RC10

That particular build used B44 CVDs... I did the same thing:

http://www.rc10talk.com/viewtopic.php?t=29737