Page 1 of 1
Bearing question
Posted: Thu Nov 01, 2007 11:50 am
by Jschoenb
Hi all, need help again. I recently ordered some 1/4" rear axle bearings for my RC10T. However they seem way to big. I don't even think they would fit on a 3/8" axle. Do I need some kinda spacer or did they ship me the wrong size? Any Ideas?
Thanks
Re: Bearing question
Posted: Thu Nov 01, 2007 2:49 pm
by beardxxxd
they fit into the hub carrier?
difference between ID and OD
i give them thumbs up
http://www.avidrc.com/shop/?action=category&id=1
Re: Bearing question
Posted: Thu Nov 01, 2007 5:56 pm
by scr8p
if you have 1/4" rear axles: 1/4" i.d. x 3/8" o.d. plain bearings
if you have 3/16" rear axles: 3/16" i.d. x 3/8" o.d. plain bearings