Hi all, need help again. I recently ordered some 1/4" rear axle bearings for my RC10T. However they seem way to big. I don't even think they would fit on a 3/8" axle. Do I need some kinda spacer or did they ship me the wrong size? Any Ideas?
Thanks
Bearing question
Re: Bearing question
they fit into the hub carrier?
difference between ID and OD
i give them thumbs up
http://www.avidrc.com/shop/?action=category&id=1
difference between ID and OD
i give them thumbs up
http://www.avidrc.com/shop/?action=category&id=1
RC10 Team
-
scr8p
- Administrator
- Posts: 16734
- Joined: Tue Feb 07, 2006 9:46 pm
- Location: Northampton, PA
- Has thanked: 33 times
- Been thanked: 1193 times
Re: Bearing question
if you have 1/4" rear axles: 1/4" i.d. x 3/8" o.d. plain bearings
if you have 3/16" rear axles: 3/16" i.d. x 3/8" o.d. plain bearings
if you have 3/16" rear axles: 3/16" i.d. x 3/8" o.d. plain bearings
Create an account or sign in to join the discussion
You need to be a member in order to post a reply
Create an account
Not a member? register to join our community
Members can start their own topics & subscribe to topics
It’s free and only takes a minute
Sign in
-
- Similar Topics
- Replies
- Views
- Last post
-
- 4 Replies
- 862 Views
-
Last post by Stumpy
-
- 8 Replies
- 1030 Views
-
Last post by SoCalSnakeEyes
-
- 7 Replies
- 991 Views
-
Last post by ericsp2
-
- 7 Replies
- 1303 Views
-
Last post by civilguy
-
- 4 Replies
- 562 Views
-
Last post by Coelacanth
-
- 2 Replies
- 662 Views
-
Last post by Dr. Robotnik
-
- 4 Replies
- 670 Views
-
Last post by Lowgear
-
- 5 Replies
- 859 Views
-
Last post by a01butal
Who is online
Users browsing this forum: No registered users and 4 guests