RC10Talk - The Net's Largest Vintage R/C Community

Slowly getting the hang of these cats, but I've got a few parts which I need I.D'd

A: Front trans, -no slot for tensioner plate ?
B: Layshaft? -Pin positions look different to my procat manual ?
C: One way shaft part ?
D: Thrust bearing...what off ?
E: Coarse tooth belt and thrust race pinion ?
F: Wheel adaptor ?
G: ?
H: like a centre/diff pulley but with no ball holes ?

Cheers, Jools

E is a YZ10 pulley and belt.
F is a wheel adapter for Yokomo wheels on your cat.
G is a rear upper suspension mount.
H is a rear diff gear. Original cat diff has three. Only the middle one has diff balls.

(Anyone got any rear transmission housings they can bear to part with?)

Talk with CATS. He has a pile.

A= would be from the any cat before the procat, ie xl/xls etc
G= the same as above

Let me know if you want to part with the yokomo wheel adaptors in the pic. I recently purchased a set from a member here, and one of them has stripped holes . So, I need one to round out my set. LMK Thanks -Jeff

All parts excluding E & F are original CAT SWB & XL (not XLS or procat)

Have a look at the instructions, these will help as it shows images of the part and where they go

http://www.retromodelisme.com/manuel_page/3/cat-schumacher.html

http://www.retromodelisme.com/manuel_page/53/cat-xl-schumacher.html

Hope this helps

John

That's cleared that up then, mostly early Cat, Ta boys. (What's a YZ10 Brad?) 'scuse my ignorance!
Jools

Jools wrote:That's cleared that up then, mostly early Cat, Ta boys. (What's a YZ10 Brad?) 'scuse my ignorance!
Jools

That'd be a Yokomo, matey... welcome aboard!

Alex

That'd be a Yokomo, matey... welcome aboard!

http://www.rc10talk.com/viewtopic.php?f=29&t=2654

Yes. Welcome!