Graphite RC10 to compete

[dspy8083]

I just got back into the hobby 6 months ago and picked up a nice graphite chassis car with stealth for $39. I have noticed that as stock the car is extremely light on the front end. So as I built it up, I wanted to shift weight towards the front. I canted the batter to get us much weight up front as possible. I have since made the battery straight forward with dual original RC10 batt mounts (pic to come soon). Here is what I have done so far:
1. RPM rear arms (1/8" longer than stock)
2. B4 hub conversion with B4 longer cva's (I had to machine inboard bearing mount .125" to clear the cva and countersink to prevent shaft bind during suspension travel (this widened the rear end approx. 1"!) *Also I added drive nut spacers with 2.2 tires/rims which added another 5/16" width per side. The rims I have a deep dish which also come out an additional 1/4" per side (1/2" more total).
3. B4 steering (allowed more forward mounting of the servo)
4. Castle 4 pole 4600kv and Castle esc
5. Lipo (forward mounted up to servo)
6. Stealth 2.25 being rebuilt for this weekend
7. Titanium turnbuckles and RPM ends

I intend to run the car a long time despite it's age which I why I didn't mind changing things over to a modern B4 design.
The rear track width is about 10.5" with the front of about 9 1/4" with stock 2.2 narrow buggy tires/rims. The extra width made a huge handling improvement!

My next stage is to get longer arms up front to equalize it to the rear track width. The current arms are the Associated RC10 long arms (but not long enough especially when compared to a B4! I don't mind narrowing the suspension arm pin mounts to accommodate longer arms. I really want this car to outdo (hopefully) the new breed!

Any suggestions for front long arms and arm mounting mods (if needed)? I don't mind doing a little modification but not a total overhaul/custom job unless the bug gets superbad, though it is merely bad at this point.
*if there aren't arms available I may make some????

[midse]

Ol thread I know, how is the car going- I'm totally green - forgotten so much stuff. As a kid I would of been able to recollect what mods were needed and what changeover kit was available and what mag. You could [email protected] about it. Not sure if rpm arms are wider but I'm planning on racing an rc10 ce in factory spec but modding a graphite (parts)car similar to your idea

[RC104ever]

You could try the Dynatech front arms but it needs a 10t front end. Or there are rpm front arms available on tower hobbies site. There was also a guy in the classifieds selling some arm kits.