RC10Talk - The Net's Largest Vintage R/C Community

The ball studs that hold the front sway bar on my RC10 have broken off leaving the threaded part inside the front A arms . Any good tips or tricks to get the pieces inside the A arm out without ruining the arms? Also, provided I can get them out, what is the part number for the ball studs? I have the edinger manual but it lacks all the part numbers for the screws.

Thanks in advance.

AndrewSi wrote:The ball studs that hold the front sway bar on my RC10 have broken off leaving the threaded part inside the front A arms . Any good tips or tricks to get the pieces inside the A arm out without ruining the arms? Also, provided I can get them out, what is the part number for the ball studs? I have the edinger manual but it lacks all the part numbers for the screws.

Thanks in advance.

Dremel with an engraving head.

Oh, and safety glasses.

Bump!

Does anyone know the part number for the correct balls studs for the front sway bar on a gold pan?

Dubro 2/56 ball studs will work. I just used parts out of the two listed to make a complete sway bar set up.

http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXD897&P=7
http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXD899&P=7

New arms would be easier

Todd

Awesome! Thanks guys. Those ball cups look to be the same aswell.