RC10Talk - The Net's Largest Vintage R/C Community

I picked one of these up off ebay with the intent of putting it on my buggy, but it appears different than the regular stealth, it is layed down like? Are the internals the same and can they be swapped?

What did I get here?

Either the gt AND t2 suspension parts work and front tower,tierods bearings slippers but trannys no.bolt up patterns are different.Don

the gt trans uses a layed down arrangement due to the nitro engine. Someone here built a sweet mid motor car using that trans and a custom motor mount. I tried to find it the other day but wasn't having much luck.....

Learn something new everyday. I wonder are the internals the same, so if I had a regular stealth case I could swap?

Though a custom mid engine sounds cool to.

i think the internal dif is alot larger than the regular stealth i though about doing the same and the internals are way bigger

Paul

The GT diff is the large B2/T2 sized diff, not compatible with the original Stealth casing. The top shaft, slipper and bearings will swap over though.

OK thanks for the info, if anyone has a link to the custom mid engine car using this trans even better.

I think that would be *THIS* thread.

actually, the one I was thinking of was an oval truck I think......

jwscab wrote:actually, the one I was thinking of was an oval truck I think......

I believe you are right. I think it was Ford...drawing a blank right now even though I've bought a ton of stuff from him. Would've been in this part of the forum within the last 6 months...damn it I hate when I have a name just outta my grasp
Todd

AHA...PBR Allstar (Ford) is the one that did that custom oval with the gt tranny that I'm thinkin of. Its on page 5 of the 'Spring RC10Talk RC10T Competition!' thread in this part of the forum...I can't seem to search it then put the link in here...keeps showin up as the search even though its on the thread.
Todd

yeah, i know...it probably was Ford, but searching I just can't find it.....I hate when that happens....

going from your tip, it WAS Ford:

http://www.rc10talk.com/viewtopic.php?f=36&t=12643

nice!!! thanks!!!

This is another one of his:
http://www.rc10talk.com/viewtopic.php?f=36&t=14518&start=60
bout half way down the page is his but I can't remember if that one had a gt tranny in it or not
Todd

same gears inside t2/gt= 2.60:1

GAMMACRUSH wrote:same gears inside t2/gt= 2.60:1

B4,t4 and sc's are all the same also.