Cleaning nylon parts

Post by **illshou** » Sun Sep 13, 2009 9:48 am

Was wondering if anyone has tried bleach to clean their nylon parts? Gonna try it and see what happens. Oh ya, does anyone know the turn count of a SLOT MACHINE STOCK, and JOEL JONSTON MODIFIED(made by losi I think). Just found them in a box of stuff at my parents place

Post by **LowClassCC** » Sun Sep 13, 2009 10:01 am

i have tried bleaching parts with zero luck. there was no difference before and after.

the slot machine is a 27 turn stock motor. the other one i don't know.

Post by **Grumbles** » Sun Sep 13, 2009 5:46 pm

I have not tried any of these yet, but I found this post yesterday and it may help you.

http://www.rc10talk.com/viewtopic.php?f=35&t=10999&p=112041#p112041

Post by **littleVETTE** » Mon Sep 14, 2009 10:13 pm

oxy clean and warm water always works. just make sure you wear some rubber gloves. that stuff could be irritating under the skin, if you have your hands in it for a while.

if you have oil or other greasey crap on the part, clean it off first. you'll do more bad than good.

RC10Talk - The Net's Largest Vintage R/C Community