Page 1 of 1
My first composite RC10 project
Posted: Fri Feb 16, 2007 5:25 pm
by Synergy
You guys make this project stuff look a lot easier than it is
So this chassis hasn't got enough holes for a stealth so it must be fore a 6 gear tranny right
This body don't go around this chassis massive girth is there a one that will
. I look forward to all the laughing smilies but can you include some advice among the hysterics please
Stealth Trans
Posted: Fri Feb 16, 2007 5:44 pm
by Sharkman
ferretti,I'm assuming you have a Stealth for it. Some time ago,there was a metal template that AE made to drill the 6-gear chassis for Stealth trans. If you want to drill the chassis,maybe you have a Stealth chassis already drilled,make a small template of scrap G-10 or even lexan,and "be careful" thats a nice ride
Posted: Fri Feb 16, 2007 5:59 pm
by Synergy
Thanks Sharkman, the car came with a stealth that I wanted to use as I was considering running it in vintage competitions. I do have a couple of 6 gear trans I can put in it, I don't want to drill it I'm not that confident and I have seen a few properly messed up doing it.
Posted: Fri Feb 16, 2007 6:23 pm
by badhoopty
an mip tranny would fit without drilling.
Posted: Fri Feb 16, 2007 7:01 pm
by Synergy
I think what I might do is strip this back down and integrate one of my 6010 cars into it as I planned and use this nice stealth car for the Tekin chassis that's on its way.
Posted: Fri Feb 16, 2007 7:05 pm
by badhoopty
tell me you didnt spend over 50 bucks on the tekin chassis...
Posted: Fri Feb 16, 2007 7:17 pm
by Synergy
Posted: Fri Feb 16, 2007 7:21 pm
by badhoopty
right on.
Posted: Sat Feb 17, 2007 7:33 am
by ra272
really nice car, I think it will look great with a black dyed 6 gears tranny.
Posted: Sat Feb 17, 2007 7:48 am
by Synergy